You do not need five machines to get strong at home. You need one good barbell, a little floor space, and a plan you can repeat. This workout is built on the five big barbell lifts: squat, press, deadlift, row, and hip thrust. Five moves, three sets each, about 30 minutes total.
It fits right in with what garage gym lifters are posting right now: simple barbell challenges, full body sessions with one bar, and HYROX style conditioning finishers built around a barbell complex. No fancy setup, no waiting for a machine, just load the bar and lift.
Key Takeaways
- 5 barbell moves, 3 sets each, 60 to 90 seconds of rest between sets, about 30 minutes total.
- Start with just the bar. When every set feels clean, add a small plate per side next session.
- Lock your collars before every set. Plates that slide change the balance and the lift.
The Workout (30 Minutes)
Warm up for 5 minutes first: 2 minutes of easy walking in place, 10 bodyweight squats, 10 arm circles each way, and 10 hip hinges with no weight. Then work through the moves in order. Rest 60 to 90 seconds between sets.
- Back squat, 3 sets of 8
- Overhead press, 3 sets of 8
- Romanian deadlift, 3 sets of 10
- Bent over row, 3 sets of 10
- Hip thrust, 3 sets of 12
Form in 5 Steps
Step 1, Back squat.
Set the bar across your upper back, not on your neck. Feet about shoulder width apart, toes turned out a little. Sit back and down like you are sitting into a chair, knees tracking over your toes. Go as low as you can while keeping your chest up and your back flat, then drive up through your whole foot. If your heels lift, the weight is too heavy or your stance is too narrow.
Step 2, Overhead press.
Hold the bar at your upper chest, hands just outside your shoulders, elbows slightly in front of the bar. Brace your core, squeeze your glutes, and press straight up until your arms are almost straight. Move your head back a little so the bar clears your chin, then bring your head through at the top. Lower slowly back to your chest. Do not lean back like a limbo move. If your lower back arches, drop the weight.
Step 3, Romanian deadlift.
Stand tall holding the bar in front of your thighs. Push your hips back, keep your knees soft, and lower the bar down the front of your legs. Stop when you feel a strong stretch in your hamstrings, usually just below the knees. Drive your hips forward to stand tall and squeeze your glutes at the top. This move trains the same hip hinge that powers a kettlebell swing and a HYROX sled push, and it is the best way to build strong, healthy hips at home.
Step 4, Bent over row.
Hinge forward until your torso is about 45 degrees to the floor, back flat, bar hanging below your shoulders. Pull the bar to your lower ribs, elbows driving back past your body. Squeeze your shoulder blades together for one second, then lower slowly. Do not jerk the bar up with your hips. If your torso rises with every rep, the weight is too heavy.
Step 5, Hip thrust.
Sit on the floor with your upper back against a low bench or a sturdy step, bar across your hips, feet flat and knees bent. Drive through your heels, lift your hips until your body makes a straight line from shoulders to knees, and squeeze your glutes hard for one second at the top. Lower slowly. Keep your chin tucked and your ribs down. If your lower back does the work, move your feet closer to your body and use less weight.
What Weight Should You Start With?
Start with just the bar. The bar itself weighs 20 kg, and that is plenty while you learn the moves. When all 3 sets of every move feel clean and controlled, add a small plate to each side next session. Small jumps beat big jumps. Progress you can repeat beats a heavy single rep you cannot control.
What You Need
One barbell, a set of plates, and a pair of collars. That is the whole setup.
The Eyries Competition Barbell, $300 is IRONBAY's highest spec bar: a 190,000 PSI alloy stainless steel shaft, 28 mm shaft, 50 mm Olympic sleeves, 8 precision needle bearings, dual bronze bushings, and a 2,000 lb load capacity. The aggressive volcanic knurling keeps the bar in your hands on heavy pulls without tearing up your grip on every set.
Lock the plates with the Eyries Magnetic Barbell Collars, $40. They snap on fast, stay put through squats and hip thrusts, and stick to the bar or a rack between sets so they never roll away.
Load it with IRONBAY Bumper Plates, from $17.60. Bumper plates are kind to your floor and your bar, and they all share the same diameter, so your deadlift always starts from the same height no matter how much weight is on the bar.

© IRONBAY Fitness. Images not for commercial use.
FAQ
Can you build full body strength at home with just a barbell?
Yes. Squat, press, deadlift, row, and hip thrust together train your legs, back, chest, shoulders, arms, and glutes. Add a little weight over time and one barbell covers a complete strength program.
What makes a competition barbell different from a regular barbell?
Tensile strength, spin, and grip. The Eyries Competition Barbell uses a 190,000 PSI shaft, 8 needle bearings for smooth sleeve spin, and aggressive volcanic knurling for grip. That matters most on Olympic style lifts and heavy pulls, where a cheap bar feels dead in your hands.
How many days per week should I do this workout?
Two to three days per week, with at least one rest day between sessions, is plenty. Do the same five moves each time and add a small plate when all sets feel easy. Strength comes from repeating the same lifts, not from changing the workout every week.
Why do my plates slide during hip thrusts?
Usually the collars are loose or missing. Lock a collar tight against each plate before every set, and check them again after your first set. Plates that slide change the balance of the bar and make the lift feel uneven.
Shop online now. IRONBAY Fitness opens Nov 1, 2026.
Updated October 25, 2026. New to training or coming back from an injury? Check with a coach or physio before you start.


